For "Teapot" pour ladles, cupola receiver entries and spouts, cupola slagging box syphons, Or for any metal transfer application.
Clay graphite tubes are available in a range of sizes from 25 to 250mm diameter and lengths up to 1400mm (large diameter tubes, over 200mm OD, can be manufactured up to 1900mm long).
Pre-fired shapes for the transfer of ferrous and non-ferrous metals from furnace to furnace or from furnace to ladle. Launders provide a metal transfer system that has a high resistance to erosion and is virtually maintenance-free when installed properly. Available in many sizes to suit most runner systems
Also suitable for use as spouts in:
Clay Graphite rods can be used for stirring additions into all types of molten metal ensuring good distribution of the additions in the melt. These have very high erosion resistance ensuring long product lives. Almost no inclusion is observed in the melt, thereby maintaining metal properties. They can be supplied with Threaded End or MS screw xed joint to facilitate extention.
Clay Graphite tiles are used as hot surface refractory lining. Being graphite based products, they offer high non-wetting characteristics. This results in lower inclusion rejection and prolongs lining life.
Clay Graphite stirrers can be used for mixing additions into all types of molten metal, ensuring good distribution of the additions in the melt. They can also be used to remove any dirt or oxides from the surface of the molten metal. They can be supplied with Threaded End or MS screw xed joint to facilitate extension.